Home >> Articles

Purchase our intelligent SFP optical module with DDM function

SOPTO

Our intelligent optical fiber module SFP module supports MSA protocol. Our SFP fiber optic transceiver not only supports the local digital diagnostic monitoring (DDM) function but also supports the remote digital diagnostic monitoring (DDM). When two intelligent optical modules are on the same fiber optic cable, each end of the modules can obtain the diagnostic data from the corresponding another end.  In addition, our intelligent SFP optical module supports the Dying Gasp function. We.

Continue Reading…

The tips for us to purchase the fiber optic transceivers

SOPTO

When we purchase the fiber optic transceivers, we should follow some tips. Firstly, we must sure that the optical modules should be used for what brands’ switches (such as CISCO, HUAWEI, H33C, D-Link, HP, RuiJie, ZTE and so on). And then we should make sure the model and the parameter of the optical module we need. For example, the types of fiber optic transceivers include SFP modules, GBIC Transceivers, XENPAK transceivers, X2 optical modules, 10G XFP and 10G SFP+ Modules. For the .

Continue Reading…

The cost is the key reason for the 100G optical module to be large-scale applied

SOPTO

The key reason of 100G failed to be large-scale applied is the relatively high cost currently. In the era of the 100G, the optical module cost is very expensive. From the point of view of the fiber optic transceiver cost, the cost the 100G optical module is several times higher than the cost of the 10G fiber optical module. Especially in the part of the optical module technique, the cost of this part is the key for the whole 100G system. The optical module itself has to face the challenge.

Continue Reading…

Why the price of Cisco fiber optical module is so different?

SOPTO

Firstly, we should know that the Cisco fiber optical module is divided into several categories. The GBIC Modules and the sfp modules belong to the 1000M modules. X2 fiber modules and sfp+ modules belong to 10000M modules. Generally, the price of 10000M is greater than the 1000M module on the same level. Secondly, take SFP module as an example, the SFP module is divided into single mode and multi-mode, etc, with different price. Usually, the ultra-long haul SFP module is the most expensive, .

Continue Reading…

Is the price of 10G SFP+ modules cheap?

SOPTO

The 10G SFP+ Modules refer to the series of optical modules with SFP package and 10G rate. The 10G SFP+ optical modules are mainly used in the 10Gigatbit Ethernet, Fibre Channel and the Optical Supervisory Channel (OSC). Due to different manufacturers, the price of the 10G SFP+ modules is different. Sopto offers the common 10G SFP+ module, such as SFP-10G-SR??a href="http://www.fiber-optic-modules.com/sfp-plus-modules/10g-sfp-plus-module/sfp-plus-lr-1310nm-10g-10km20km-module" target="_bl.

Continue Reading…

The cost comparison between GPON and EPON

SOPTO

We can’t simply say that the cost of GPON is higher than EPON. GPON is more expensive than EPON if we calculate by a single optic port. However, GPON will be cheaper than EPON if we calculate by the cost of network construction. Because from a view of the bandwidth and business support ability, each port of GPON accesses 64, even 128 users and each port of EPON only accesses 32 users. In addition, in a actual network construction, the cost of central office equipment accounts for less.

Continue Reading…

The low cost and high bandwidth technology-EPON

SOPTO

Before the advent of the EPON, the APON technology has appeared and it was standardized by ITU-T in 1998. However, APON systems had not been developed as expected because of the complicated technology, high cost and the limited bandwidth. EPON has the advantage of low cost, high bandwidth and more suitable for the transmission of the data business so that EPON solves the problem of broadband access more thoroughly. The main difference between EPON and APON is the link layer protocol. The .

Continue Reading…

To reduce the cost by SFP+ and QSFP+ copper cable assemblies

SOPTO

The SFP+ and QSFP+ copper cable assemblies provide an amazing transmission speed and keep a complete signal at the same time. Importantly, these products only consume lower power and generate fewer heats. And this feature is crucial for managing the cost of air conditioners effectively and solving the growing important environmental issues in the environment of the data center. The SFP+ model supports the transmission of 10G Ethernet and provides a backward compatibility for 1G Ethernet. .

Continue Reading…

The cost of optical interconnection will be reduced greatly

SOPTO

Parallel optical interconnect is realized by parallel optical modules and optical fiber ribbon cable. The parallel optical module, which based on the VCSEL array and the PIN array with 850nm wavelength, is suitable for the 50/125vm and 62.5/125cm multi-mode fiber. The electrical interface adopts the standard MegArray connector and the optical interface adopts the standard MTP/MPO ribbon cable. At present, the common parallel fiber optic module includes 4-road fiber optic transceiver and 12-.

Continue Reading…

The full range of FE SFP module with reasonable price

SOPTO

The 100Base SFP fiber optic transceiver is mainly applied in the Fast Ethernet. Working with the fiber, these Fast Ethernet Transceivers provide a complete bi-directional data link for the data communication to realize the high-speed and transparent forwarding of the data information. As a professional manufacturer which produces and sells fiber optic modules, we provide a full range of FE SFP module, including 155M dual fiber SFP modules, 155M WDM SFP Modules, 155M CWDM SFP modules and 1.

Continue Reading…

Record Count:14 1 2

Categories